12/11/2023 0 Comments Broken wood katanaHere are the steps to reassemble a katana Handle. It’s following the same sequence you used to disassemble the katana handle. Or, you just want to make some decorative tweaks to your katana. You can still use some of the current parts for example, the seppas will still come useful, while you might opt to replace the tsuba or the tsuka. If you’re replacing the handle altogether, make sure you have all the parts ready for reassembly. If it’s maintenance, now you can easily clean the blade and the tang. Now you can proceed with the task you want to do. Now you have the whole tank revealed, and your handle parts on the side. Remove the seppa between the guard and the blade.Then, remove the first spacer (seppa) that’s located next to the guard.Simply slide it off to reveal the tang (nakago). There are also two seppas (spacers) and the tsuba (guard). The biggest one is the tsuka, or the handle. You’ll see that the handle is composed of several smaller parts. Don’t hammer onto the guard directly, as you can damage it. Now you’re ready to remove the handle.Do that until you see that the blade is getting looser. Next, start tapping onto the wooden block gently with a hammer.Then, place the wooden block onto the blade and right next to the guard (tsuba).Make sure the katana is away from your legs in order not to cut yourself. First, place the katana onto the floor.The other method of removing the handle is with a block. Be careful so that the edge doesn’t fall out inadvertently! Now you can start removing the handle. Continue tapping until you see that the blade is loose.Start tapping onto your hand that you’re holding the blade with using the other hand.With the mekugi out, hold the katana in your hand vertically, with the blade facing away from you.There are various methods of getting the handle off. You’ll find a wooden block handy here if you’re a beginner if you’ve done this before, you can do it without the block. But the handle is composed of various smaller parts, so you’ll need to be careful here. Now you’ve taken the mekugi out, you can remove the tsuka (handle). Gently remove the mekugi and place it somewhere safe.Make sure you’re hitting from the right direction, as the mekugi is tapered. With the punch in place, start tapping gently onto the punch with the hammer.You’ll find the mekugi somewhere in the upper part of the handle (tsuka). There is also a punch included helping you get the peg out. The mekugi is a tapered bamboo pin, which means it can only be removed in one direction.įor this, you’ll need to use the hammer from the katana maintenance kit. This peg holds the blade together permanently. The mekugi is the peg located in the middle of the handle of katana. ![]() Here are the steps you need to follow to disassemble the katana Handle. Be cautious here, as you’re dealing with a razor-sharp blade that can cut you easily. The first part of replacing the katana handle is disassembly.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |